Good cables for my rear speakers

Build your own speaker wires if you are looking to save $$. I am trying SIlver at the moment,but you should be able to fifnd Spoo;s of Thick Gauged Copper then Litz Braid them or twist them into runs and terminate them yourself.

There is alway Belden CAT Cable which can be used,but I would rather spend alittle more to get the exact gauges I am looking for in the particular runs needed.

For CAT Cables look to Jon Risch's designs which can be found at Audio Asylum's Cable BB.

Anotehr source is Parts express,but I'd want better than theirs.

Good luck !

You want thick , as in 10 gauge wire . I forget whether I used Sound King or Parts express but ran them through my ceiling when I finished my basement . Then look for a pair of Walker High Definition Links on Audiogon, and you will be a happy camper. But think Thick !!

Hi,

Thank you for all of your comments. I think I will go for one of the cheaper alternatives that you've suggested.

Regards, Raanan

Check out the AudioQuest GR-8 cable:

http://www.audioquestcables.com/

A 50-foot pair will cost you about $260.00. Not a bad deal.

If you want to same some cash just go get a roll of monster cable. 40 bucks for 50 foot roll. Not the cheapest but not overly priced, besides rear channels dont exactly have a very demanding soundtrack, i guess unless you listen to alot of multichannel music or just have money to burn there is not too much of a point in worrying about it.

just my humble opinion of course!

-----slappy's slappin disclaimer----
i do not claim to be the end-all-know-all-guru of audio. i am just offering my humble advise on the subject and mean no offence to anybody
--------------------------