2. speakers
  3. 1011642033

Dented Tweeter?

Hello All,
I have a pair of 2000 cherry Hales Design Group Revelation 3s. Unfortunatly during shipping one of the tweeters has a small dent in it less than 1/2 cm. I can't tell audibly that there is a problem, but I have to think the dent causes some dispersion problems. Since Hales Design are out of business, does anyone have any suggestions as to the condition of the tweeter, replacing the tweeter or info on Hales drivers. Any help would be greatly appreciated.

Rega Planet 2000
Forte F44 preamp
Classe Ten power amp
Hales Design Group Rev. 3s
w/ sonic euphoria and mit cables
scootdog
drfosgate
1 posts
 
I dented the dome on one of my Seas metal dome tweeters. I removed the tweeter baffle and rubbed out the dent from behind with a Popsicle stick that had soaked in water for a while to make it softer. The dent is still slightly noticeable at very close inspection, but appears just fine from a distance. A soft dome should be just as easy, just forget the water on the stick.

BTW, are you interested in selling your F-44 preamp?
roachone
20 posts
 
Chewing gum! That's right, chewing gum. Works every time. Chew it for awhile, then stick it to the dome, gently pull,Bam! Fixed.Try it, it works. Hope this helps you.
akaddict
51 posts
 

So I noticed my system was sounding harsh. And it grew and grew on me until I was sure I needed new speakers (see previous post about dented Thiel tweeter).

Kind of as a last resort I changed out the dented unit and immediately it sounded better. I think the tweeter must have been resonating or something - it wasn't hitting the magnet.

Changing it made a big difference.
dawgbyte's avatar
dawgbyte
325 posts
 
I have a pair of T-5's and have a very small dent in one of the tweeters. I had a technician put a light sensor across the tweeter to ensure there were no tears or wrinkles etc. He said the slight dent was okay and wouldn't affect the sound quality in any way whatsoever. They sound bloody amazing.
eldartford
4,262 posts
 
Bishopwill has suggested the method that has always worked for me. Prick the dent with a needle, and pull it out. In fabric dome tweeters the hole is barely visible. If you feel bad about the hole plug it with a tiny drop of glue. And most important...do all this while no one is watching, and they will never know the difference.
More to discover