2. speakers
  3. 1046397470

Please help - system "brightness" problem

I recently purchased a new pair of speakers and stands - Tyler Acoustics Reference Monitors to replace my B&W Matrix 803s in a small listening room. I was looking for a tighter, faster speaker, particularly in the low frequencies.

The system includes Linn Ikemi CD and Plinius 8150, HT Truthlink ICs and Pro 9 cables. I never had a problem with brightness, but the new speakers have made the system very "bright".

Any suggestions would be greatly appreciated.
Joel
joeldoss
joeldoss OP
94 posts
 
Neil, Zaikesman, and Warren,
Thanks for your advice. It seems at this point, patience is the key, of which I am often lacking.
Joel
drrasta
224 posts
 
The Tyler ref monitors can sound bright, particularly with solid state (which Ty prefers). There is a switch on the back to "step down" the highs which helps a bit. Also try a high quality jumper if you're not biwiring. That will help clear up the highs and they'll sound less hashy. You might also try experiment with positioning and room damping.

Good luck.
nrchy's avatar
nrchy
2,124 posts
 
Go to
www.rivesaudio.com
and see if their model can assist with speaker and chair place. I did it and it worked very well.
phasecorrect's avatar
phasecorrect
2,013 posts
 
All good advice...plus what may sound initially "bright" may sound different as your ears adjust to a new speaker...and again this might not be the speakers fault...what you often gain in detail can be perceived as bright through poor recordings and electronic matching...it is the "double edged" sword of hi-end..I have not heard the the Tylers but they are highly regarded here and on other sites...good luck...
phasecorrect's avatar
phasecorrect
2,013 posts
 
Joel...I should have said "certain" recordings instead of "poor"... cheers
More to discover