2. analog
  3. 1389541808

Brinkmann Bardo and Tri-Planar VII-U armrest issue

Just got a new Brinkmann Bardo. It was a snap to put the Tri-Planar am to the arm board drilled for this arm.

I measured the spindal to pivot distance of 233.5mm with my Feickert Protractor and set up the cartridge with the MintLP.

The issue I have is when I put down the arm, the arm will touch the arm rest and not fall at the beginning of the first track. By touching the arm rest, the arm is bump to several groove from the beginning of the track 1. I did try to fix this issue for the arm rest being too close to the platter by turning the armpod but without success if I want to keep the right S2P distance. Maybe I am doing something wrong. I would appreciate any comment/help.
acadie
dougdeacon
3,338 posts
 
+1 to Ralph's (Atmasphere's) posts. Just do what he said. I've corrected two TriPlanars this way myself.

Don't take the screw out all the way, loosen just enough to make the adjustment.

Be careful not to stress the bearings. Hold onto the VTA tower, not the arm.
acadie OP
54 posts
 
Problem fixed! Thank you very much Ralph for your suggestion. It was a learning experience.

Acadie
dougdeacon
3,338 posts
 
:-)
dougdeacon
3,338 posts
 
Ralph,

As this info isn't in the owner's manual, it ought to be included in the TriPlanar Tips thread. Please consider posting a synopsis there.

Doug
atmasphere's avatar
atmasphere
11,953 posts
 
^^ good idea- and done.
More to discover