2. cables
  3. 1399546289

RCA to XLR adapter vs buy a balanced cable

Hi, I have a phono stage with XLR or RCA output. Till now I was connecting it by RCA IC. Having changed the preamplifier to a balanced one I have now two options:
1) buy good RCA to XLR adaptor (Cardas?) to enter in the preamp (please note my power amp is unbalanced, so output from pre will be by RCA
2) Using same amount of money (approx 160 Eur) for a full balanced cable(In this way, phono stage output will be balanced and pre input too)

It might sound a stupid question, but I have limited budget for my toys and need to maximazi benefits
Thanxs if you would give attention to this
Cheers
Daniel
ad010685
ad010685 OP
102 posts
 
Thanxs but still what you advise? I have phono preamp out XLR or RCA choice . Line stage is no choice input only balanced, while output can be RCA optional to XLR.
Shall I get a balanced interconnect between phono and line stage, or just use a normal high quality RCA with adapters?
kijanki's avatar
kijanki
4,428 posts
 
It might be debatable if XLR sounds better than RCA (requires additional circuitry to make it balanced), but having choice between RCA+adapter or XLR I would choose XLR for it's superior noise rejection (assuming the same cost).
czarivey
5,946 posts
 
XLR between phono and preamp OK, adapter for poweramp isn't necessary, because amp isn't balanced and you can keep RCA.
hdm
1,062 posts
 
Definitely buy the balanced phono lead. Your cartridge is a balanced device.

If you have a balanced phono preamp chances are it will sound quite a bit better on the balanced input/output now that you have a balanced input on your preamp providing both are balanced designs and don't simply have the XLR's thrown on for show.
zavato's avatar
zavato
1,399 posts
 
I would contact the manufacturer of the phono stage and ask which output is cleanest. I had the same question and asked Pass Labs (manufacturer of my phono stage and integrated) what's the best connection. They told me that out of the phono stage RCA is recommended. Thus just becuase there is an XLR output don't assume it's the best way to go.
More to discover