Zamdrang, a quick look at published specs for the Stingray & Dalis reveals the following challenges:
*output impedance Stingray 20 /100 Hz: 2,8/2,6ohm resp. Quite high, given that...
*Dali, "nominal" impedance (i.e. 1W/ at 1kHz???): 4 ohm
Further,
* Stingray output power triode/linear modes= 20/40W resp. which gives you a maximum undistorted sound pressure level on paper of 99/102dB at one metre away fm the speakers. Minus 6dB for every doubling of distance so at 4m away (usual listening distance) the max would be ~87/90dB. That's loud but not that loud ESPECIALLY when you have a lot of low frequency content (which eats up power)...
An approximation of real world dynamics may be had through horn-loaded speakers... such speakers would typically mate well with tube-based amps.
As a side issue, the Stingray output impedance specs: 20Hz-2,8 / 100Hz-2,6 / 1kHz- 2,0 seem to indicate that the output transformers are optimised for higher frequencies rather than lower frequency interfacing with the speakers. Also the, the 5ohm "optimal speaker load" plus "damping factor: 10" is puzzling; it would make more sense if this read: "optimal speaker load: min. 5ohm". Manley is a serious company so, if I'm not missing something, we can assume it's their marketing copy that got mixed up -- certainly not their engineers dept!
*output impedance Stingray 20 /100 Hz: 2,8/2,6ohm resp. Quite high, given that...
*Dali, "nominal" impedance (i.e. 1W/ at 1kHz???): 4 ohm
Further,
* Stingray output power triode/linear modes= 20/40W resp. which gives you a maximum undistorted sound pressure level on paper of 99/102dB at one metre away fm the speakers. Minus 6dB for every doubling of distance so at 4m away (usual listening distance) the max would be ~87/90dB. That's loud but not that loud ESPECIALLY when you have a lot of low frequency content (which eats up power)...
An approximation of real world dynamics may be had through horn-loaded speakers... such speakers would typically mate well with tube-based amps.
As a side issue, the Stingray output impedance specs: 20Hz-2,8 / 100Hz-2,6 / 1kHz- 2,0 seem to indicate that the output transformers are optimised for higher frequencies rather than lower frequency interfacing with the speakers. Also the, the 5ohm "optimal speaker load" plus "damping factor: 10" is puzzling; it would make more sense if this read: "optimal speaker load: min. 5ohm". Manley is a serious company so, if I'm not missing something, we can assume it's their marketing copy that got mixed up -- certainly not their engineers dept!