Capacitors for BAT VK-60

I tried a few brands like Cardas cables and p-cords which are warm-sounding but the difference was not so important.
So, I'll try a few tubes first, now I'm using some TELAM 6N8S I think...

I will repeat,thanks for your support John.

I have experimented with the Jensen copper foil oil caps and did not find them warm at all. I"ll share a neat trick to warm up the sound of most any cap. On the output lead of the capacitor, solder on a 1" pigtail of Kimber varistrand copper wire. So, at the circuit board connection and the capacitor lead out wire is were you make your solder connections.

Damaradona - If you felt that the Cardas cables and power cords didn't make enough difference, I am not sure capacitors will either. I think you need to try different amps instead. This will give you the big change that you seek, especially since you say the sound wasn't thin until you got the VK-60. Just my 2 cents based on what you have said so far. Changing tubes can have a big impact but it won't be as much change as, say, a McIntosh or VAC tube amp would bring.

Arthur

Thanks Reb.

Arthur, perhaps you're right...Perhaps it won't be...
But a new replacement...?
Jesus, not again...

Try changing the V1 6SN7 first, that should have the most sonic effect of anything mentioned in this thread yet so far.

-Ed