Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Agear and guys, let's get the name of the main devices inside the Lightspeed Attenuator correct, they are not solar cells, they are not optocouplers, they are LDR's (Light Dependent Resistors). These LDR's are made from (back in the old days) Cadmium Sulphide, which back in the 70's were almost impossible to match up for me, and were unreliable, I needed about 100 units to get 4 matched. Now the ones I use are made of something else they won't say what they keep it close to their chest, but it has enabled me to match 4 out of about 30 units and the reliability is no longer a factor.
Some of the "tech heads" are saying that it's the Cadmium Sulphide or whatever it is that these LDR's "Light Dependent Resistors" are made out of , is what makes the Lightspeed sound better than metal or carbon film resistors, this could have a slight bearing.
But you know what I believe and have seen if you read my explanation on DIY Forum or read my PDF broucher about "Dynamic Contact Bounce"
Cheers George
1mt each each side of the Lightspeed Attenuator of Eichman Express Six unshielded.
I have found shielded cable a little constricted compared to unshielded of the same construction, I believe these days with CD high level output 2v there is no RF break-through any more. Shielded cable is just a hang-over from the low output mV phono days.

Cheers George