Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
There is no way around the lack of muting issue at "0" from what understand, unless you unplug the LSA.
It looks like the one on top on the Intact Audio site. I wonder why Dave would choose to use one over the other.
Its quite possible that John Chapman's modules can not be implememted manually.
I see that George recommended lowering my gain of the amp or source. My amp input impedance is 47k ohms and output impedance of my DAC has been confirmed at 600 ohms by Rega. What numbers do I need to look for in an amp or source to match with my 98 DB sensitive speakers so that I achieve lower volume in the "0" volume setting?
I don't think it has much to do with impedance. It is the input sensitivity of your amp, it gets to full power output too easily. For example, my amp I use with a passive only needs .8v to reach max. power output. My other amp that I use with an active line stage requires something like 2.8 v to reach max. output, and in most cases requires the gain provided by an active line stage. The other side of the chain would be to reduce the output voltage of your source so the overall gain structure is lowered. I have no idea how you do any of that.

No matter why you do, the LSA in any system that it is appropriate for will still produce some volume a zero setting, and just should not be that intrusive, except with high sensitivity amps and speakers combined.