Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
Hmmm, Interesting. I'm a believer in upgraded power cords, power supplies and outlets but I can't see how this could make the lightspeed sound better.

Correct me if I'm wrong, George, but the light in your Lightspeed Attenuator is really only controlling volume, right? I don't see how there could be "dirty" light....

I'm confused, but if Banquo continues to hear a difference I'll give it a try also.
Banquo363, you can tell a smp wall wart a couple of ways.

One is they are half the weight of a linear, but if you don't have a linear to compare it to then that's hard.

The other way is to get an AM radio and go near it tuning up and down the am dial, you will hear it if it's an smp.

Another way is that they have nearly 2 or 3 times the amperage ratings for the same given size of linear wall warts.

Cheers George
B_limo hi, the smp high frequency rubbish gets into everything even the grounded chassis, interconnects, input and output, even your amps and source can get it via the wiring or even through the air, especially if it's a bad designed one.
The AM radio trick (above) will really give you a big shock about the run of the mill smp wall warts and why the high frequency rubbish is like a cancer for hiend audio.

Cheers George