I think the point is a well designed speaker (at any price point) will always benefit from better upstream components, including the amp. A lot of people make the mistake of buying expensive speakers and then match them with mediocre electronics. Some speakers fare better with poor electronics, but many of the higher end designs need lots of quality power to get them going properly. My rule of thumb is the amp/pre needs to cost 1.5-2x the speaker cost. And I use monitor speakers.
Amp more important than speakers?
The common wisdom seems to be the opposite (at least from speaker makers), but I have tried the many speakers that have come thru my house on lesser amps or my midfi A/V receiver and something was always very wrong, and things often sounded worse than cheap speakers.
On the other hand, I have tried many humble speakers on my my really good amps (& source) and heard really fine results.
Recently I tried my Harbeth SHL5s (& previously my Aerial 10Ts, Piega P10s, and others) on the receiver or even my Onkyo A9555 (which is nice with my 1985 Ohm Walsh 4s, which I consider mid-fi), and the 3 high end speakers sounded boomy, bland, opaque.
But when I tried even really cheap speakers on my main setup (Edge NL12.1 w/tube preamp) I got very nice results
(old Celestion SL6s, little Jensen midfi speakers).
So I don't think it's a waste of resources to get great amplification and sources even for more humble speakers.
My Harbeth SHL5s *really* benefit from amps & sources that are far more expensive than the Harbeths.
Once I had Aerial 10Ts that sounded like new speakers with vocals to die for when I drove them with a Pass X350 to replace an Aragon 8008.
Oh well, thanks for reading my rambling thoughts here...
So I think I would avoid pairing good speakers with lesser amps,
On the other hand, I have tried many humble speakers on my my really good amps (& source) and heard really fine results.
Recently I tried my Harbeth SHL5s (& previously my Aerial 10Ts, Piega P10s, and others) on the receiver or even my Onkyo A9555 (which is nice with my 1985 Ohm Walsh 4s, which I consider mid-fi), and the 3 high end speakers sounded boomy, bland, opaque.
But when I tried even really cheap speakers on my main setup (Edge NL12.1 w/tube preamp) I got very nice results
(old Celestion SL6s, little Jensen midfi speakers).
So I don't think it's a waste of resources to get great amplification and sources even for more humble speakers.
My Harbeth SHL5s *really* benefit from amps & sources that are far more expensive than the Harbeths.
Once I had Aerial 10Ts that sounded like new speakers with vocals to die for when I drove them with a Pass X350 to replace an Aragon 8008.
Oh well, thanks for reading my rambling thoughts here...
So I think I would avoid pairing good speakers with lesser amps,
- ...
- 114 posts total
- 114 posts total