Can I bridge Rotel RB 1080


Hey everybody, just bought a pair of B&W 800D and am really looking forward to them. A little problem, though..my existing amp, a Rotel RB1080 (200w 8ohm), will not bring out the best in the 800D. I'm fairly confident it just does not have the grunt for the 800D. I do like the sound of the Rotel, so am thinking of finding another one and running a pair in bridged mode. If I understand things right, this would give 400w per channel and should provide enough power to make them sing. But I've also heard this would cause the Rotel to overheat. Can anyone shed light pls.
toddmorr
Looking at the owner's manual, it doesn't appear that you can bridge the RB 1080. You could sell it and buy a RB 1090. That's a MONSTER amp and sounds very good.
As Mofi indicated, it appears that the RB-1080 cannot be bridged.

Also, be aware that an amplifier that is operated in bridged mode will "see" a load impedance equal to the speaker impedance divided by two. Like many B&W speakers, the 800D reaches impedances at some frequencies in the lower part of the spectrum that are quite low, apparently about 3.1 ohms in this case. So a bridged amplifier would see that as about 1.5 ohms. Very few bridged amplifiers will be able to handle that low an impedance with good sonic results, and some might overheat as you indicated, or go into protective shutdown mode, blow fuses, etc. I suspect that most high powered amplifiers that are capable of handling that kind of a load impedance when bridged will be quite expensive.

I'm not familiar with the model Mofi suggested, but I would choose among amplifiers that can provide adequately high power without being bridged, and that preferably have a specified continuous maximum power capability for a 4 ohm load that is twice what the rating is for an 8 ohm load.

Regards,
-- Al
I've been on the lunatic fringe for 3 years now with the same speakers. They are potentially great, but can be mediocre with lesser electronics, room, cabling, etc. Rotel makes good stuff for the money, but will certainly be a limiting factor in your setup. At the very least I would look at 500 watt monoblocks. Many good choices for amps depending on your budget. Its probably not the answer you were hoping for but to cut corners with amps and power is not a good idea.
Welcome to the big leagues. B&W 800's - $24,000.00 (retail) Rotel rb 1080 (used) $600.00 just doesn't make sense and you will not get the sound the 800's can produce as you indicated. Please do yourself a favor and shop for a new amp and pre, and you will say " I can't believe I thought the Rotel sounded good????? My suggestion is McIntosh 400 watts and up. Your speakers can handle up to 1,000 watts! I've heard the 800's with Krell and it sounded amazing. Good clean power and you will be one happy man! Let us know what you decide on.