Amp/Preamp or AVR for home stereo and entertainment


Looking to get an AVR or amp/preamp setup to go with a possible combination of speakers, devices, and a television. What I have: a Samsung 55" 1080p LED smart tv, a Technics turntable of reasonable quality, and some speakers. The speakers are as follows: KEF Carmina II's (8ohm, recommended 80-150w), Spica TC-50's (4ohm), Fortura 12 Heil AMTs, and some powered 20w Yamahas that I could use for rear surrounds. Maybe Even some little Braun bookshelf speakers. The Forturas are unfortunately missing the tweeters, perhaps the only reason they were ever any good in the first place. No less, a 12" woofer has to be good for something, right? I don't have a subwoofer yet, so maybe they could take that role. I know that the Spica's are supposed to have great soundstaging but drop off a bit on the highs and fall apart low down so more or less require a subwoofer. Figure the KEF's are the best bet as the speakers of choice for a stereo set up. Maybe the Spica's. This stuff is all quite vintage but in seemingly decent condition.

I'm thinking I'd like the stereo (2 channels) to be the focus, with the television's audio secondary. Are there some all in one receivers of relative quality that can do this? Do AVRs exist that can drive a dedicated stereo set up and sound great to boot? Should I ditch these old speakers and buy a whole new setup? I'll need a CD player too, as my primary physical media collection is such. I have a blu-ray player which will in play and could in theory use it for the CDs but might prefer a dedicated unit.  I was looking at the Denon S930h for sub $600, but I noticed it doesn't have a phono input, and that it really is enhanced for various HD inputs, upscaling, and surround sound processing. I like film and tv, but I will need to get the most out of the cds and digital media. Blue tooth, USB, line in, wifi, even HDMI etc. These are all a plus, which is why this unit was attractive. Also, the power output seems adequate for the speakers I've got.

Oh, and is there any way I can get some use out of the 12" woofers in the Fortura towers? The tweeters are long gone and apparently very expensive/hard to find. Can I wire them in series to the KEFs? My knowledge of electricity is limited.

Budget, ideally, is less than $1000, including AVR or amp/preamp, cables and the CD player.

Naturally, I'm looking for quality on a relative budget. What else is new? Thanks in advance!


128x128samgoldenberg
Furman PST-8D on it's way, and the Integra 80.3 has been purchased! Emails and evidence that it went back to Onkyo for the HDMI board replacement/fix, and it test drove just fine. Guy was a real mensch, through in all of the missing cables I needed to get the whole rig fired up - MIT EXP S2 speaker cables, among other things... Whoa, doggy!
Sam,

On the low end, I recommend Furman with SMP and LiFT. Really good bargains for the noise they remove.

Shop around and you can get them for real discounts.

After this, PS Audio has a nice range.

Best,


E
Here's a question:

What sort of AC Regenerator/Surge protector is needed for a set up like this? I know of the Panamax brand, but not which model would bode well for this system. 
Next question!

For wireless connectivity when in the mood for laptop DJ mode, which are the better wireless audio adapters? Do you have to get applications with all of them? All I want to do is buy a device that I can plug into RCA/Optical input, and play from my Apple laptop's iTunes. Chromecast looks a bit too tied in to Google, but I could be wrong. Apple Airplay? If I am going to get an Apple TV anyway, maybe it is moot? But at least with the airplay, so far as I understand it, I won't have to have it "turned on" like I would the Apple TV, to allow for streaming. Also, I think blue tooth is out as the sound quality is not what I'd like to hear. I see there are clearly some audiophile grade devices, but which ones rise above the rest, in regards to quality of sound reproduction, ease of use, and cost? 

Thanks, as always.
@samgoldenberg,

That price for the Integra pre/pro is great. Very neutral sounding and featre packed. Audyssey MultEQ XT32 onboard is also a plus.

Bill
So I found an Integra DHC-80.3 PrePro/Preamp for sale on craigslist. Assuming it is in good, working condition, should I give this a go? It has HDMI, which is a must for connectivity with certain devices. Asking $500. Looks to be at least $2-300 below most asking. My understanding is that Integra is a sister company to Onkyo? 
The A23’s XLR input is convenience only. It’s still an unbalanced input. :(

The A23 is a very good, modern sounding amp, I highly recommend it as a solid buy, especially at the price. Quiet, free of grain or glare or strain. Quite solid.

Best,

E
So Pop has a Parasound A23 Amplifier that I've offered to buy for $500. We were both happy with that price. Now for the Preamp/AVR... The A23 has XLR so ideally what I'd like is something with, say 5.1 channels, XLR, HDMI, Phono, and a few more RCA inputs. Does that exist for around $500?

Are there better ways to spend my money than on the A23?

This is a cool community, thanks for the speedy replies and advice.
Post removed 
Thanks for the responses! My Dad never fully dissolved his previous HT setup and at least some of the components were Parasound. Not sure what is remaining, will give it a look today. I suppose the main drawback with an older receiver is the lack of HDMI inputs for HD monitors and devices. 
I would consider going with a 2 channel system for both music and video. Put your budget into a quality integrated and a pair of speakers. Integrated could have HT pass through should you wish to expand. 
Right now I’d decide which is my aim. Music or home Theater. The latter is gonna be far more involved and lots more ‘spensive..

Some feel music is the end all be all and will say go with an Integrated amp first. And that path is fine enough.

Given you want to improve upon the home entertainment experience as you noted the nice TV and blue ray player I’d opt for a different theme or plan.

just starting out I have always gone with a multichannel receiver. always. But, that's just me. Were I doing it all over again, I’d try hard to get one of the top tier receivers and having had a few, Onkyo is a very solid option with very good support, in or out of warranty. Well built and very reliable. Sony is another decent choice. My Onkyo has out lasted my Sony though. Performances are pretty much a toss up.

Ensure whichever way, the multi ch reciver is capable enough for 4K video, either HDR or now, Dolby Vision, if possible. Or look for HDMI 2.0 on the video side. I’d never buy one with less than 110 – 120 wpc either. Mo’ is better.

having a multi ch receiver enables one to add many things, as you are able. or, when you are able.

Speakers were first. I’d opt in for a 4.0 aray. Then likely add a sub. HT just ain’t HT without a sub. I can live without a center channel long before I can do without a sub woofer. Subs are a must for HT.

Then, I’d upgrade the mains. Usually moving them to the surrounds. If possible.

Once I had all four ch, and a sub better off, I’d add an amp for the mains. Either a multi ch amp or a nice two ch amp. Use the reciver to do the processing and run the surrounds.

Then its off to upgrade heaven. The world is your play pen. Where ever, what ever, when ever you have the dough for the upgrades.

Ultimately, you wind up with a bed room outfit and a very nice main HT rig. If you don’t have to sell off stuff to do your upgrades everytime.

I’ve even bought older speakers and sent them back to their maker for upgrades, essentially then having brand new speakers for much less than buying brand new units..

This is the idea for all of us. Many even enjoy the process. I’m more of a “Are we there yet sort though” and don’t care a ton for the crap in the interim. But yeah, even still, it is fun when new stuff comes into the house and you find out exactly what is what by ‘experiencing your plan’.

Either way, getting a sub as soon as possible will really add to the AV experience.

Be well, J

Complicated set of questions.

If you want to stay 2-channel focused, the Parasound Halo P7 is a great multi-channel pre. Paired with an Oppo 103/105 you would have all the decoding you need but no room correction.

Otherwise I also hear good recommendations for the Krell HTS processors.

Personally I haven't heard an AVR I really liked. I do like Arcam but I think they got out of the HT market? Not really sure.


Best,


E