Audioquest is bright??

Hi I am using A.Q. granite double runs biwire with Proceed amp. 250 watts per . and Macintoh 134 as myA/V control center. after about a week the granite was warm in the bass and mid , highs crisp but not harsh . thanks Bill Head

Not sure about the new AQ cables, but the older ones used all solid core conductors that took a longer time to break in.

Thanks. Hi Bob, it is the power amp. I was surprised reading a post here recently where someone said AudioQuest was bright. Hence my post here. Being solid copper with no silver plating and insulated strands, I would think Granite is as un-bright as one could get other than maybe Cardas.
So I will break in some more.

this possibly shows that the previous speaker cable may have been less revealing & was perhaps covering up something else. If new, first break the replacement cables in for a good 2 to 3 weeks.
Then I might also check elsewhere to find out if the actual source of your brightness is coming from otherwise, rather than just covering it up.
Source component
AC cord
Line noise conditioner
Signal interconnect
shelving cones & footers
Right now you really don't know where you're at, & should perhaps consider some other experimentation. If all else eventually fails then I'd suspect an amp + Granite + 804 synergy issue, but not right away.

This may not be a brightness problem from the Audioquest cables but a speaker placement problem, as I have found switching cables or components require the speakers to be moved, sometimes a slight toe in or out will make a huge improvement, I find it to make more of an improvement with components than cables but try it with the cables as it does make a difference. If you still have the brightness problem you may want to try a few different brands along with IC. Another thing to do is explore the room treatment thing! Happy Listening!

my friend's experience. Extreme Clear = Extreme Unclear.

Another vote to allow more break in time. Some AQ Pythons I once purchased displayed a really obnoxious midrange at about 50 hours use which then disappated with extended use. Up to this experience, I was sceptical of break in claims.

I agree they probably need some break-in. Give it a couple weeks.

Perhaps it it break-in. Put about 200 hours on them and then decide.

I run B&W's 805 with an Arcam A32 and use Audioquest Granite (previously Slate) and the sound was quite bright until I upgraded my ICs from Nordost Blue heaven to Red Dawn. Now I have the right balance. I don't think AQ is especially bright, maybe you should look elsewhere in your system, as I did.