New! Cerious Technologies Lumniscate cables


I have been listening to my system through Bob Grost’s Cerious Technologies Matrix cables for the past 5 years and have been very happy, happy enough to have completely stopped shopping for cables, and I had been cable swapping for a number of years.

 

I had tried silver cables in the past, and it always seemed like a compromise, such as getting more detail for less warmth. When I found out that Bob had a new cable line than utilizes proprietary pure Silver ribbon conductors made for Cerious Technologies in Germany my curiosity was peaked.

 

Bob sent me a full loom of what he calls Lumniscate cables, speaker, interconnect and power. I installed, powered up and walked away. The speaker cable were very heavy, much like the Matrix cables before them so I knew what to expect. I came back about 5 hours later and could not believe my ears just how big the difference was. As cliche as it sounds a veil was now missing that I didn’t know existed. I was immediately struck with the immense clarity and realism. It was startling. I couldn’t quite wrap my head around the enormity of the change that had occurred in only a few hours with essentially no burn-in. Bob told me, “just wait until they’re broken in.”

 

This cable appears to have some very sophisticated technology involved other than just a different type of wire or braiding techniques, shielding etc that every other Cable manufacturer claims is what makes theirs special. I’m not an engineer but I am curious about what makes them tick, so I asked Bob what was in these things and this was his response.

 

How is this done? Cerious has developed a proprietary method of           forcing the aqueous Graphene into the smallest nook by injecting it under pressure. After each conductor or “Damping Jacket” (both employ the same Aqueous Graphene) is “filled” the entire cable is placed in a vacuum chamber under extreme high pressure sucking out every pocket of oxygen and pulling the Graphene into intimate contact with the pure Silver and Carbon Fiber backbone fusing it into one coherent conductor.

Through this process we have achieved an increase of over 20% concentration of Graphene in each conductor versus Graphene Matrix. The introduction of our aqueous Graphene solution in our damping jackets has resulted in damping at the atomic level for both our individual conductors and cables as a whole.

Matrix was a large step up from Extreme, especially with regard to low level signal devices, namely interconnect and digital cables. Due to their smaller scale more elements of our ideal design were able to be instituted. In Lumniscate we have functionally turned our Loudspeaker Cables and Power Cords into large signal “interconnects” utilizing the same 6N 99.9999% pure Silver as the backbone of all Graphene Lumniscate products. Every inch is custom made and configured even before each individual conductor is hand made out of this pure Silver, Carbon Fiber (made by Toray, the finest available), Graphene and Liquid Ceramic which acts as the agent for our aqueous Graphene. Each conductor is housed in a medical grade Teflon tube, and then hand wound into a specific configuration within the outside jacket. Our aqueous Graphene solution is then flowed into our outer tube to surround the individual conductors and “lock” them into place. This process does require some time for the Graphene to move into place. For this reason, users should avoid moving Lumniscate once connected within a system, as this damping will improve over several weeks yielding quieter backgrounds over time.

Here we must address “the sins of the past”, as many have had bad experiences with pure Silver cables being bright and “overly detailed”. As a material physicist, individual materials are not defined by a single characteristic. When you say “a carbon fiber composite” everyone thinks of something rigid and prone to explosive failure characteristics. If knowledgeable carbon fiber structures can be made that are flexible, especially when combined with other materials. The same can be stated for Silver and the Carbon Fiber we employ within our conductors.

Carbon Fiber, as an individual conductor, can be “tube like” in its presentation and is a perfect complement to high purity Silver. The use of aqueous Graphene is an integral part of successfully combining 48,000 strands of Carbon Fiber (even more in our power cords and speaker cables...) and Silver into one integrated and coherent conductor.

The result is a cable that simply “disappears”. Graphene Lumniscate sets new standards for transparency and neutrality, which are hallmarks of all Cerious Technologies.

 

As I listen tonight, I have over 150 hours on the cables without moving them, and I feel like I’ve broken through that wall. There is now a wonderful ease to the sound and yet very dynamic, beautiful clarity, realism and next level transparency that I have not experienced in my system. There is an unrestrained flow to the music, a fullness of soundstage and yet an emptiness of color, resulting in feeling that there is nothing in between the amp and speakers. I’m lucky to easily hear differences because of my quiet components and revealing speakers to help discern the difference.

 

I put my favorite LP on the platter, the three blind mice recording, Midnight Sugar by Tsuyoshi Yamamoto. It’s already a good recording but now the piano is in the room with me. The bass is tight, and everything is well balanced. I can close my eyes, and I’m in the studio watching them record.

 

I’m listening at a lower level tonight, not needing to turn up the volume. There is so much detail now at lower volume it’s astonishing. The noise floor is just nonexistent. I also am realizing just how colorful the Matrix cables were, and I suppose all cables color the sound to a degree, but now I understand what real transparency is.

 

Bob said these cables were a whole new level of transparency.  I think it must be said that’s such an understatement. Without any break-in, the Lumniscate cables made the Matrix cables, the cables I’ve been happily living with for the last 5 years, sound just above average.

 

In my excitement to get these cables broken-in, I put everything in and let it run. The sound has changed significantly during this break-in period. Now I feel that I’m I can systematically remove cables and insert them one at a time to try and determine which ones are making the most impact.

 

After purchasing these cables, it’s recommended to not move them after placement. just let them break-in properly to maximize results. More to come on that.

 

I’ve never owned super mega-dollar cables but they must sound like this….. if they’re lucky.

 

System:

Backert Labs Rhythm 1.3 Pre

Coda No. 16 Power Amp

GamuT RS5i speakers

Modwright Oppo 205

Technics SL1200 GAE, DS Audio Grand Master cart, Integrity Tru-Glider Tonearm

PS Audio P15 Regen

Dedicated power line to Furutech GTX outlet.

lancelock

So after hundreds of hours with these cables I feel like they just keep smoothing out. The sound is absolutely incredible. The big secret is to not move the cables at all. It makes it very difficult to do A-B testing against other cables but at this point I don’t care.

I had a great moment listening with my wife last night. I stopped halfway through Hejira and switched my Cerious lumniscate digital AES back in, taking out another cable. After I restarted Hejira, she looked up and said, “what did you just do? This sounds much better. Did you switch a cable?”.

It’s tough to do A to B comparisons because every time you move the damn cable you end up waiting a couple of hours for the sound to settle back in. It does smooth out and just sounds so incredibly transparent.

 

If I had to rank them for impact:

  1. Interconnect 
  2. Power Cable
  3. Speaker Cable

Of course it depends what you are comparing them to.

 

The surprise to me is how good the power cables are, and this ranking does not take anything anyway from the speaker cables. They are fantastic. I have to mention that I have a Luminscate umbilical cable between my Modwright Oppo 205 and the PS 9.0 power supply.  It was a special order and it made a big impact.

 

Hi everyone...Bob from Cerious.

We finally have Lumniscate up on the website! Improvement coming to the website, too soon. I wanted to let everyone know that we are having an introduction special on Lumniscate for repeat customers. You can now get 100% trade in on Matrix towards Lumniscate even if you got a discount on your Matrix. So if you purchased Matrix during our Cyber Monday deal and got 50% off your Matrix, you will still get 100% of a full Matrix price off of a trade for Lumniscate! Just because I love you guys and this is my way of showing appreciation for being the great customers you continue to be. Thank you so much!

Bob

CT 

Just ordered a 3 foot Lumniscate power cord to run between the QSA Red outlet in the wall and my power conditioner. It’s replacing an old entry level Synergistic cord, so I’m hoping for a nice improvement. If the reports I’ve read prove to be true, these could well be my end game cables. I’m using Graphene Extreme cords on my CD transport, DAC and amp. Assuming I like what I hear with this one, they’re next in line to upgrade.

I should have it end of next week, or beginning of the following. I’ll update after I’ve run it in a bit.

@tommylion 

I do have the Lumniscate PC from the wall to my P-15 power conditioner and from P-15 to preamp, dac, streamer, TT, etc. It sounds great. There is no downside.

Wow! just got my Lumiscate power cord earlier today. You may think some are over the top in their praise of these cables, but my experience, with one power cord, a few hours in, confirms their reports. Transparency, neutrality, natural detail, and realism are all there, right out of the gate! Can’t wait to hear how things sound after it settles/breaks in for a while!

they are awesome out of the box, and even better after a week of physical settling and playing music...

I have long been a fan of Audio Note UK. Their cleverly, and appropriately, named top-of-the-line silver “mains” cable is the SOOTTO (SO Over The TOp). I believe it goes for something like 12K. To me, 12K, for a power cable, is crazy money. Still, having read several descriptions of what it brings to a system, by people who have tried it, I put it on my bucket list to try, if I ever win the lottery/have money to burn.

The reason I bring this up, is that this Cerious Graphene Lumniscate power cord is actually doing, in my system, what I imagined the SOOTTO might, if I was ever fortunate enough to try it. Now the SOOTTO could, possibly, be way better, I don’t know. The point is that I no longer really care. I now have something, for a small fraction of the price, that has exceeded my hopes and expectations.

ozzy,

I have not. I’d like to, but I have pretty decent speaker cables now (Synergistic Research Foundation SX). I think I’ll work my way through power cords and ICs, before doing them.

This Lumniscate power cord has got me thinking the most ridiculous thoughts; like “Do I really need to go any further with my system?”

@tommylion Not a bad problem to have can only last so long until the bug hits once again...LOL!

Glad to hear the power cord is working out very well for you.

These days, each time I play music on my system, of whatever style or genre, I hear things I’ve heard in live music, but rarely, if ever, have heard in reproduced music. Do you get the idea that this Lumniscate cable might be doing something extraordinary in my system? Might it do the same in yours…?

Post removed 

 I am a returning customer and can navigate the website. However, no one at Cerious Technologies responds to mutiple emails or phone messages (phone goes directly to voice mail). Are they still in buisness? Jeff

They’re still there. They are having a great sale on all the Matrix that have been traded in

Hi jl35: Have you corresponded with anybody at Cerious Technologies lately? If so, was it by email or telephone? I/m a returning customer and have been using a pair of Matrix interconnects and couple of Matrix power cords for the past few years.. I really like the Cerious Tech house sound and would like to trade my  Matrix inerconnects  in towards a pair of Luminscates. Good listening. Jeff

Hi yoby...not lately....I traded up to Lumniscate from Matrix oiver a year ago...but I am also a long time customer, and always hear back from Bob within a few days, typically an email exchange...maybe holiday stuff going on...definitely a great upgrade and worth the time and patience...

@jl35: Bob at Cerious Tech has responded to me by email. I sent him a pair of Matrix interconnects for trade in towards a pair of Luminscates. His pricing is more than fair and his customer service is still first rate. Good listening, Jeff

I just installed the new Luminscate interconnects from Cerious Tech. Right out of the box they are very impressive with no break-in at all. I was using a pair of Matrix interconnects that were traded in for these prior to this. I know it's way too early for a proper assessment of them. Outstanding customer service from Bob at Cerious Technologies. Good listening, Jeff

@yoby  - how's the interconnects coming along?

Website looks nice Bob!   Is there still a sale on Matrix cables?

Dave

Does anybody know how the Cerious speaker cables may compare to Iconoclast SPTPC? I'm considering switching them for Cerious Lumniscate Speakers cable. I'm also considering to replace interconnects for Cerious Lumniscate XLRs (I have now Iconoclast OCC 4x4 XLR Cables).

I'm really happy with the Iconoclast but I have the impression that the Cerious would provide a little smoother and warmer experience.

In my system Luxman 509x amp, Holo May KTE DAC, Klipsch Cornwall 3 speakers. I mostly listen to Roon through Musica Pristina Acapella 3 streamer.

I'm new of this hobby, I appreciate everyone thoughts!

Fabrizio

Has anybody compared the power cables to other popular options from AQ, Transparent or Nordost?