Thickest Power cord with Power distributor?

miracle1980 there's always one thing you can do try it both ways and see which sounds better.

+1 @jond - try and listen

@miracle1980 power quality depends on (too) many things.. first I would recommend to test outlet point by plugging vacuum and lamp into it, and check if light dims when vacuum motor turned ON.. if you see no “visible” IR voltage drop, then few hundred milli-ohms less resistance power distribution will reduce voltage ripple inside your amp lil bit.. if light dims, - then going thick wiring options way will not help much..

Thanks all for the comments!

At the end I tried the 2 cables, from wall to Power Conditioner (Ansuz C3)... and the differences were very minimal.

I felt like the Zavfino was more powerful (higher volumes perceived) and a little bit smoother. Again...these might be just perceptions.

It’s really difficult to switch off all the components...change the Power Conditioner cable...re-start all the components again and compare.

So...I ended up keeping the Zavfino from wall and the Ansuz (P2) connected to the streamer.

The other test might be to swap the cables after one week or 10 days... but, do I really want to do that?

Probably not :)

Thanks for updating your impressions. So many a thread just gets left hangin'....