Best vibration tweaks


The components in my system rest on a Lovan rack (not filled). Until recently, I hadn't considered doing much more to control vibrations in my system. But I've noticed that their are some relatively inexpensive (a dangerous phrase in our hobby) tweaks in this department that are available. I'm curious to know what experience others have had with things like Vibrapods, filling their stands with weighted material, airmats, Audiopoints (?), those half-globe gel balls (don't know their name), etc. If you've tried them, how much of an improvement (if any) did they make? Several of these appear to be mutually exclusive, so which do you recommend most? Thanks for your input.
macm
Kubla: Before spending $80-$100 or so on butcher's block and X amount on cone points talk to Ken at Neuance about setting up a shelf/platform specifically for your turntable. He's a vinyl guy himself and the Neuance did wonders for the CAL that I use as a CD transport. I have played around with Maple and cones for a year now and the Neuance sounds much better in my application. The shelves that I had made are custom (with eight sides, not counting the top and bottom) and were only $165 each.
thanks for that dekay. it's hard enough to explain some of this crap to my friends. butcher blocks under all my gear just might have been the end. what i'd really love is one of those turntable isolations Randy at optimal enchantment had under the oracle. the sandbox. can't be hard to make one of those. right??
So far my vibration experiments have been:
1- mass loading
2- mass loading +inner tubes
3- inner tubes +MDF shelving
4- inner tube sandwiched between MDF panels
5- inner tube + MDF + steel balls underneath
6- inner tube + MDF + brass cones
I´ll skip 3-4 additional combinations of the above
11- Got rid of the inner tubes and concentrated on brass cones variations....
12 The latest and so far best results have been achieved through use of large heavy (40-50 lb) MDF made silica sand filled box as base, a resting hard plate on top of the sand and brass cones.
In my set up I have no rack (I´m learning on vibration before attempting one.... so my source, preamp and amp are resting on tile floor with the above mentioned support.
I Haven´t tried soft type approach yet.

I have found that investing time experimenting with vibration is a high return activity.
Don´t expect good results to jump at you, have patience and you´ll be rewarded!!
Could provide more details but I would like not to be lengthy in this post
Best to all
Luis
I like the Walker Valid Points... but before you spend a lot of money, you might try some of the low cost tweaks listed in the forum. Resonance control can be time consuming, but also rewarding, as you learn what works and what does not in your setup. Good luck.
Cheap is the way to go: just got a used marble cutting board over 5/8" thick for $15. Free bicycle inner tube under it and it makes a wonderful TT base!