Tweeter life

If they're working well, why replace them at all?  

If they’re working well, why replace them at all?


Well thats what Richard Gray told me, when i asked him 2 months ago,, he said Quote<< do they produce sound?>> *Yes* , <<Then they are ok>> Now after the tweets are on his test equipment,,he says,, **they are out of balance* = perhaps its time for new tweets, @ $350 each,, well, they are 17 yrs old,, but for 10 yrs i had no sound system as i could not finda line stage preamp to mmatch the Defy7,, So lets just say, with new xovers,, why not replace the Millennials. ?? uh? why not? anyone care to dispute,, the old ones with new voice coil diaphrams will go up for sale on ebay.
Who know they may sound close/same to old ones.. I just don’t know.. But again its time after 17 yrs to go ahead and replace,, This way, I will never have to worry about changing the Millenniums ever again.
paul
New Orleans
The Audiophile Mountaineer.

I just googled *do magnets lose power over time*, Yes overa  long period of time magnets lose some power.
Of course the Millenniums use the high tech Neodynum Magnet system , which is far superior to ferro fluid magnet system. 

mozartfan, AFAIK ferrofluid in tweeters is used for damping and cooling.  It has nothing to do with type of the magnet.  Neodymium magnet tweeter might be designed with or without ferrofluid.

The fact that magnets "lose some power over time" speaks against replacing them, because other speaker magnets (midrange and woofers) lose some power as well.  I would rather lose some efficiency than risk unbalanced sound.

this one?

https://www.madisoundspeakerstore.com/seas-soft-dome-tweeters/seas-excel-t25cf-002-e0011-millennium-tweeter/?gclid=Cj0KCQjw1qL6BRCmARIsADV9Jtb3LV5tzck5ZGy4hoktbabo5NS8aNdE2QZ_HdjTcJbyahoVUVVClEEaAhrxEALw_wcB

madisound is a great source, you might call them.

replacing tweeters is easy, IF you can get at them. surface screws very easy, careful separation from enclosure, there is probably a sealing material you want to avoid damaging if possible.

proper sound proof seal at their perimeter when re-installing is important, ask madisound about that. you can buy sheets of gasket material at auto supply stores, cut your own circle. if they can block air and oil getting out of valve covers, they can block air around drivers.