2. analog
  3. 159752-2199

Springs under turntable

I picked up a set of springs for $35 on Amazon. I intended to use them under a preamp but one thing led to another and I tried them under the turntable. Now, this is no mean feat. It’s a Garrard 401 in a 60pound 50mm slate plinth. The spring device is interesting. It’s sold under the Nobsound brand and is made up of two 45mm wide solid billets of aluminum endcaps with recesses to fit up to seven small springs. It’s very well made. You can add or remove springs depending on the weight distribution. I had to do this with a level and it only took a few minutes. They look good. I did not fit them for floor isolation as I have concrete. I played a few tracks before fitting, and played the same tracks after fitting. Improvement in bass definition, speed, air, inner detail, more space around instruments, nicer timbre and color. Pleasant surprise for little money.
128x128noromance
noromance's avatar
noromance OP
9,833 posts
 
Chuck, I'll add a photo later.
Under the table. It moves in all planes. No detectable torque movement. Tap test makes stylus skip. Slight movement when changing records. Settles fast. 
millercarbon's avatar
millercarbon
12,531 posts
 
My DIY Spring Thing worked so well under my Moabs I tried the same only with rubber bands under speaker cables. That worked so well I used the same rubber band suspension under power cords and interconnect. That worked so well the plan is to suspend everything in the whole darn system! 

Whether rubber band or springs the thing seems to be to allow freedom of movement, ie not so weak a spring it compresses too much, but not so strong it doesn't move freely either. These with the ability to use different numbers of springs to adjust is pretty clever. Its probably slightly better to have one properly tuned spring but that is easier said than done! And this looks a lot better than a plain old spring. 

These cost more than the ones I was buying on eBay but not much especially not factoring in how they look, the adjustability, the pads, etc. So what the heck you only live once I just ordered a set. Then I'll have several different ones to compare. 

Thanks!
noromance's avatar
noromance OP
9,833 posts
 
@slaw Thanks dude.
noromance's avatar
noromance OP
9,833 posts
 
@millercarbon What is the DIY Spring Thing? Added a photo.
millercarbon's avatar
millercarbon
12,531 posts
 
Just a simple MDF platform with a spring in each corner that I built to test the concept. A very crude version of a Townshend spring platform but it gets the job done. Will make another better looking one in a few weeks and then maybe post some new system pics. Its amazing how much improvement there is to be had from such simple inexpensive tweaks.
More to discover