Subwoofer xover settings for KEF LS50W (orig model)


Yes I did search and did not see much. I figures others have done this so I'd simply ask as see if anyoen has advice. The LS50W go quite a bit lower than the regular LS50s so I'm thinking of setting the low pass xover at maybe 50hz. But I can high pass as well thru the KEFs. So I figured I'd ask here what other have done with these active speakers in terms of a low and high pass settings. Looks like KEF defaults to just a low pass 80hz which seems high. 

Also I plan to use the sub settings via the KEP app but could obviously do much of this via the REL B1 sub as well. Thx
jbs
The reason low crossover points are being recommended is because most sub manufacturers expect their clients to run the sub without a high pass filter on the main speakers. They are trying to bring the sub in under the main speakers. It is also much less noticeable way down and easier to integrate without screwing things up. You also have more flexibility in placement. But the improvement in distortion levels coming from the woofer more than make up for any disadvantage particularly with smaller loudspeakers that use the woofer as the principle midrange driver.
Your LS50s will grow to three times the size. 
Thx, the highest setting on the sub REL B1 is 95 hz. Yes, you read that right. That is where I have it now so the LS50W DSP settings do not interfere and I don't have two notches in play. I was trying to stay away from that area to keep it simple given this is a temp setup and goign way higher seemed problematic due to the sub xover. Maybe I'm all wrong about this. 

Normally I'd be running the sub at speaker level (unsing the differential hookup) but that'll wait until I put the REL with some other speakers and electronics.  
Download a sound level meter app like db on your smartphone, and stream some whitenoise (available on Spotify, elsewhere).

Then turn the sub level up and play with the crossover control. adjust level up and down until flattest in the bass region. That will give you a reasonable estimate of where your exact level and crossover settings should be. Adjust phase if available for best impact from percussion, etc. then fine tune level and xover settings from there as needed.

You might be surprised what you find this way compared to doing it by ear alone. Probably more good sound out of your sub than expected.

I had original ls50s crossed over at ~ 60-80 hz. WIth new metas, I ended up with crossover on same sub set at lowest point ~ 40 hz and higher levels than prior. Everything sounds fuller and more alive now, and just the right amount of bass on all recordings. Room is 12X12’ square which many will say is horrible for bass, but fact is it sounds really good. BEst bass I have had ever.  Sub is Klipsch sw-308, a little 8" dynamo.
Mapman, Yes this is exactly what I did :) Stereophile test CD (bass tones) and the "vintage" Radio Shack SPL meter. I start and make changes based on that and at the end dial in by ear.  

I'm sure the Metas are nice and someday I'll probably own a pair. I got these Ws to try out and admit I am super impressed. The wireless capability really makes them so easy to put anywhere and use in a variety of ways. Quite a powerful and simple device all in. Thx