Brand new Technics SL-1210GR platter wobble ... disappointed!


Got a brand new Technics SL-1210 GR. Tonearm bearing feels good, no other issues, but it has a wobbly platter. Not as bad as I have seen in Hanpins, but should a $1700 table made in Japan have this amount of wobble? My Project belt driven TT has no wobble that I can see with naked eye.


I have uploaded 3 videos on YT. Can you guys take a look and tell me if this is acceptable for a $1700 TT w/ no cart?

Debating whether I should accept this or return it. I do not want to send a brand new TT for service. FYI, I did reseat the platter at various angles to see if the wobble went away, but no such luck.

https://www.youtube.com/watch?v=Du8rBwvrhVM

https://www.youtube.com/watch?v=aQsdpmKrXhc

https://www.youtube.com/watch?v=vm7ghWgcqFo


P.S. Apologies for a bit of camera shake, but I think it is clear to see the platter move up/down


128x128dandaroy
Wow!!!

"The crutchfield resident tt expert I talked to said this amount of wobble is "normal" with these tables. Which means if I exchange it, there is no guarantee of receiving a table with no visible wobble. Or if I send it to the factory, they will send it back saying this is within normal tolerances. He said most do not complain."

Technics really needs to know about this "response" from "their" dealer.

Based upon that response I would not touch any of their current decks with a 10 foot arm.

DeKay

I have had this table for a few months now with no issues. That definitely isn't right.
Just unacceptable. What happened to quality control. Get rid of tt and buy a vpi. 
Like I said poor quality control. It is difficult with a thin aluminum casting to keep it flat. When it is machined it heats up expands then cools contracts and deforms. I guess some people are lucky and get a flat one.