Is my anti-skating too strong.


I’m trying to adjust the alignment of the Ortofon Black Quintet cartridge on my Music Hall mmf 9.3 turntable.  When I put the stylus down on the alignment protractor, the tone arm pulls to the outer edge of the turntable.   Should I disable anti skating when doing alignment or is it set too strong?  Obviously haven’t done this too often.
Also, when listening to the anti skating track on The Ultimate Analogue Test LP, there is noticeable distortion at the end of the track which indicates too much or too little anti skating.  Any guidance here?
udog
@no_regrets, if the anti skating is off the distortion will occur in one channel or the other. If it is set too low the right channel will distort, too high and the left channel will distort. Having said this orchestral crescendos always occur at the end where the modulation is tightly packed and tracking error and it's significance increases fast. If the cartridge is not positioned correctly you can get distortion here. The cartridge may just be miss tracking because it is a poor performer or worn. It could be the record is damaged from play with a worn stylus. 

Can someone please confirm or correct my thinking.  If I occasionally hear distortion in the left channel on peaks, my anti-skate is set too high (too much force to the outside of the record).  I need to decrease the anti-skate to allow more force in the inside of the groove.  Is this correct?  I currently have it set to the same level as my tracking force.  Thank you.

Im with Ozzie on this one.  I track my Ortofon a hair heavier just for security, but it sounds better without a/s to me.

Tswisla

look at the second post that MC wrote and you will have your answer.