Am I Killing My Sound?

I have a AC noise meter my power strip which is suppose to filter AC noise but it is 

two to three times noisier then the wall outlet I don't use it   got the meter on Amazon 

Enjoy the Music

Tom

IMO, the Monster is not as much worry as the 240V you are planning to split. I am not an electrician but as a carpenter/ Building contractor, I have wired some additions (Yes it’s legal) And I have only seen the instance of splitting a 240V one tim on a bathroom remodel. . It blew many sparks and a hole in my pliers when I cut, what I thought was a 120v.wire.  I suspect there is a good reason WHY this is not standard practice and I would never run the circuit this way. So the answer from my perspective is a yes to question 1 & 2.

#3 IF you had run the wire in conduit you could just add a couple ground wires to make 2 separate circuits. But since you say Romex , I doubt it is in a conduit. I’m not sure if you should run a ground wire outside the romex. Doesn’t sound right to me. The other solution if you have a ground wire + the 4 wires , you can tie onto it in the junction box for the second circuit.

The batter and safer way IMO, is pull it out and start over with 2 separate circuits

I run all hifi off a single phase and have full time motors like HVAC and refrigerator on the other. I would NEVER mix phases with hifi. Just because you installed 4 !egs doesn't be mean you have to use them, unless you are all MC.

Only you can remove the HTS 5100 and decide if there is an audible difference.

You might consider running the 8 ga romex to a sub panel. Then run separate lines from sub panel to your system, all on same phase. You would need a sub panel having 4 spaces to run two lines on the same phase. 

I would only use the power conditioner for your source components. Plug your amps directly into wall outlet.  

All, Thank you.  Great Feedback and helpful!!!