Some drivers can handle both ported and sealed enclosures, some cannot. Also, when plugging a port, you want to plug the whole length. That applies to more than just speakers ;-)
Protip: Using a sub? Plug your mains
Merry holidays, or drinking season, whichever you celebrate I support you.
For those of you with ported main speakers and subs, here’s a big tip: Plug your main speakers.
It will reduce the bass output, but also greatly reduce the movement of the driver below the port frequency. This combination increases the dynamic range, and reduces distortion, especially when used with a line level high pass filter. It also often makes integrating the subs easier thanks to less overlap. Use a sock, preferably yours and clean unless you are some weirdo. You don’t have to stuff the entire port length, just plug the end tight. I won’t be held responsible for those of you who lose their intimates inside their speakers.
- ...
- 25 posts total
Hey @testpilot - So main speakers have their own natural rolloff and that a lot of audiophiles forego the use of, or can’t, put an electronic high pass filter in line with the main amplifier. As a result, the main speakers go pretty low and the bass can get messy. By plugging the port you raise the -3 dB point, letting the sub handle more bass. The critical thing, for me is this: By plugging the ports you prevent excessive excursion below the port frequency, hopefully reducing distortion. This benefit exists whether or not you use an electronic high pass filter. If you are using an electronic high pass filter this becomes less of an issue. I'm doing a project soon I hope to better document why this work. Stay tuned. I have lots of solder and breadboards to go through. :) |
It seems the high pass filter should be enough. I have read that plugging ports can mess with the speaker performance intended by the designer. Could plugging the ports affect frequencies above the intended level at which the mains cross over to the subs? I guess the only way to know is to try it. In my system, I believe adding a HPF (Marchand XM446XLR) improved SQ when playing the system at higher volumes, but I do not perceive any difference at low-mid playback volumes. My current speakers are not ported so I cannot comment on the effect of both a HPF and plugging the ports. |
- 25 posts total