Turntable channel imbalance

@fuzztone using a Rega Fono MM pre - just on/off. So am I out of luck? Is this the table or the cart?

reverse the rca cables, does the problem switch channels?

are the rca connectors tight on both l and right?

Make sure the table is level. If it isn't, you are introducing a bias in the tonearm that favors one side.

It is most probably the phono preamp. There may be a balance control internally.

If you are fussy about balance and anybody with a system that images correctly will be you will be adjusting balance almost with every record or file. Fine balance is a preference issue plus no system puts out exactly the same level in both channels. If the mixing engineer's system is a dB louder on the left what you hear if your system is exactly neutral would be louder on the right. 

If the OP's system otherwise sounds fine, this is what you have a balance control. for. Use it. Nothing else that has been mentioned will effect balance. Anti-skating will effect tracking not balance, same for level. Tube variability can do it. A bad connection will usually cause distortion and noise but possibly volume. 

@mijostyn

I beg to differ!

Anti-skate is so important not just because of this balance in force, but because of the resulting effects it has.

Maintaining channel balance is a key factor. Unchecked, record skate would pull the stylus inwards (towards the center of the record), and would stress the inside wall of the record groove, which would place greater emphasis on the left channel. This would result in an imbalanced sound with too much left channel and not enough right.