Threshold Stasis S/150

@totem395 

I dont have the specifications for the 2ci since the Vandersteen does not have it available on the website. I am awaiting response.

@highend64 not validated, worth re-checking, have these notes on the Vandersteen 2CI Spec:

¾ inch aluminum dome tweeter, 4 ½ “ plastic cone midrange, 8” cone woofer, and a 10” active cone radiator that handles frequencies below 35 Hz. Fequency response is 28 Hz - 20.125 kHz at + or - 3db. Its impedance is at 7 ohms nominal and 5 ohms minimum, efficiency 88db for 1 watt at one meter.

----------------------------------------------------------------------

AMP: Threshold alternative, Forte’ 1a, or Forte’ Model 3, upgraded and converted:

My Pass/Forte’ Model amp is recently reconfigured to Forte’ 1a, pure Class A 50 watts now. Voltage down, bias up. Has four new 30kuf big power caps, large Torroid transformer, new bridge rectifiers, Cardas binding posts, spade connectors removed. All soldered. Not lean at all, very musical, more grunt, 47c, runs Warm at heat sinks. It’s a giant killer now. Will drive your 2ci, no issues, all goodness :)

First make sure it was rebuilt ,this amp was built probably30  years ago and especially capacitors , dry out over time and detail and dynamics sonics lost .

ask for a build sheet rebuild, ask for pictures to see the inside .

Without That just pass how much are they asking  ?

With your system I think a parasound a23+ would be a big upgrade 

perrotta consulting you can get a good deal and free shipping 

I bought one for my 2nd audio system and just put a synergistic purple fuse on back  it sounds very respectable after 200 hours runin..

Suggesting a Parasound A/B Amp to a Threshold Class A Amp is a poor comparison! Nothing in the Parasound line is comparable, and that is from personal experience with both Amps.