Really Long XLR


Looking to move my front end gear to the side wall in a new listening room.  If I don't want cables running across the floor in front in my speakers etc., then I'm going to need a set of XLR interconnects in the 40 - 45 foot range.  Wondering what other members have done and what cables have been selected for a very long run.  Obviously the companies asking $$$$ for a one meter set are not in the running.  All suggestions are welcome.  Not afraid to build my own if anyone has had great experience with bulk XLR cable.  Thanks.

128x128bigtwin

Following on from the previous post, Transparent cable is quite good value in longer runs relative to a lot of quality audio cables. They can be even better value pre-owned as there is a small enough market for long interconnects.

+1 on mogami 2549 with neutrik..

I have found the belden 1800f quite on the bright side, not a bad character if you need it.

For such a lengthy xlr, depending on rf conditions perhaps starquad is a valid choice... Mogami 2534 or canare l4e6s for less.

Made my own from Mogami cable.  You can always go to BlueJean if you are not DIY.  Those runs were about 70 feet. Cables were not the limiting factor. ( and any recording you have probably went through hundreds of feet of the same cable already) 

“and any recording you have probably went through hundreds of feet of the same cable already) ”
😂😂🤦‍♂️🤦‍♂️
 

 

Mogami Neglex and Belden equivalents microphone cable is used in concert halls worldwide, where 100 foot runs are common for high ceiling drop mics.  Every audiophile approved classical orchestral recording has this quality cabling in the path...lots of it!