Biwiring make any sense?

The only thing a designer could do to facilitate his speakers being bewired would be to have a switch disabling internal jumpers.  As far as a circuit diagram would be concerned that wouldn't make any difference, just a physical connectivity difference.  Considering the jumper mechanism that "might" make some  sonic difference.  Does that make any sense?

Maybe it has something to do with fields generated by different frequencies over a longer distance, which are usually 6-8' .

I thought this got beaten to death on some thread in the past.

Your speaker is a non-linear impedance/resistance and the cable also has resistance. Even when you apply a linear voltage to a driver, the current flow is nonlinear as a result.

By biwiring, you are moving the true ground point directly to the amplifier from the speaker’s negative terminal. You remove the inter-driver non-linearity/cross contamination (back and forth) that occurs through the crossover between the different drivers (tweeter, woofer, etc) mentioned above.

Maybe, if you had some crappy speaker with a single full range driver, it doesn’t matter (not applicable). On a regular speaker with multiple drivers, it does matter though the audibility impact of biwiring can vary due to the driver and crossover design.

Low info dudes may claim bi-wiring does nothing. Truth is...it actually does something...that you may or may hear. If you didn’t hear it, great for you.... don’t bi-wire and do whatever, save yourself the cash for an extra cable. Return the extra cable and get your money back.

Good luck.

I have Vandersteens also..,.I bi-wire, bi-amp and have everything in balanced mode.

For those wizards who think they know everything...

https://www.youtube.com/watch?v=908BWw1Bx4U