Micro Max 282 vs. Exclusive EA-10

Dear Daniel, As you know I am a careful but also skeptical
reader. They fit together I will hope. My question: in the front of the headshell we have ,say, 8m coppper wire on the 'bobin' or the plate for the coils in the cart. At the back of the rewired 'wand' or tonearm tube we have,say, 1m
phono-cable. I want mention all the soldering points. How can +/-40 cm. of Ikeda silver wire in between be of such invluence for the sound?

Regards,

Daniel and Eckert-I recently purchased a Max 282 and am reading this thread with great interest. Have either of you heard the Kondo silver wire vs the Ikeda silver? Since it is now clear that they need to be rewired, I certainly want to maximize its performance, as this is the next step.

Daniel I received my RX 5000 this week and am totally in love with it. With the limited time available, I was able to set up only an Audio Craft 4400 with Koetsu Coralstone, but this combination never sounded this good in any other turntable! If this is a precursor of what is to follow, I will be in heaven.

Now I finally understand your fascination with this wonderful sounding beast.

Logenn, welcome to the fascinating world of Nihon`s best turntable manufacturer ever! Also the Coralstone is a wonderful cartridge and your Max is a perfect match.
Regarding the silver cables: It is nearly not possible to get Kondo silver litz for tonearm rewiring, the same with Crystal Cable. Both are excellent cables. In case of the Kondo it is very difficult to work with them cause every single filament is covered with thin plastic you have to unsolder. Usually it should be done by Kondo themselves or by some special dealers having the Kondo machine.

After rewiring you should also use silver wires in your headshell (Ikeda maybe). My best experience was with a SAEC 506/30 which was rewired from the cart`s pins (headshell) to the SUT (1,2 meters). No interfaces at all.

Enjoy this world. It is different!!! glad having you on board.

best & fun only - Thuchan

Thuchan, Dertonarm,

I have a MAX282 and would like to rewire it. I have all 3 armwands (AU, SC and SM). IS it difficult? Do you know someone who can do it? Thnks

Dear Nikola, headshell leads should - as well as the phono-cable - be silver as well to preserve the minute details. In any case - it is a chain that transports a signal which gets spoiled, altered and diminished during its path through several terminals, cables, passive and active components, solder joints, networks etc. Every single step/part in this chain which you alter to transport the signal with less alternation, will sonically pay off.
Especially here in the very beginning of the path, where the signal from a LOMC is a fraction of a millivolt in voltage and similar low current.
To use a conductor with as high as possible conductivity is only logic in my point of view.
Hand -in-hand with this rewiring goes cleaning of the solder points and re-soldering with lead free 10% silver solder.
Cheers,
D.