Speaker Cable Lengths - W/ Monos

The only thing you should think about is whether you always plan on having mono's in your system. I own a 4' biwire run of AQ Sterling and Clear. I'm VERY happy with the cables but am in the market for a new amp/monos. With the cost of the original cables factored in I'm kicking myself for not getting 8' runs for the added flexibility. Good luck with the decision. By the way, what cables do you have?

I went from 7' speaker cables to 18" ones, using monoblocks. Nothing else changed, the cables were both Stealth Ultimate Ribbon. The improvement with 18" was huge! The subjective impression is of having the music MUCH CLOSER. If you can manage it, with monoblocks, I'd make the cables MUCH shorter than 4' or 5'. It might be better, more cost-effective, to sell your present cables and replace them by new short ones.

I have used both 18 inch and 8 foot speaker cables in the past with my monos, but with cables by different manufacturers so I couldn't give you a meaningful sonic comparison. For what it's worth, I replaced the shorter runs with the longer, and the longer ones (Dunlavy) sounded better than the shorter ones (Siltech FT-12), in my system (at the time, Jadis JA80s into Duntech Princesses). I still agree with the thinking that shorter should probably be better, although with my current setup I need 8 foot lengths. I will note that it was VERY difficult to sell the short pair. I think once you get to 3 or 4 foot lengths, the resale factor may go away, but you will still probably be limiting your market to owners of monoblocs unless you go with a longer length. And given your uncertainty about your future listening room requirements, you may be better off waiting until those plans firm up before doing something to your cables. Hope this helps a little.

Thanks for the responses. Sounds like chopping the cables into two sets is ultimately the way to go, although, perhaps not right now.

The cables are Tara "The Ones"

Audioman; I'm facing the same decision, and I've decided to keep my long speaker cables, then buy an 8 ft. pair of the same brand cables-- used, eg from Audiogon, and have them cut and terminated to less than 3 ft. for use in bi-amping. Good Luck. Craig