When to power off a tube amp?

I've never heard a good reason to leave them on after listening as they warm up within five to ten minutes. I've never had an explosion but there is enough plastic volume in the boards to get a good roaster that could catch a pair of drapes on fire. I'd say even though you can burn down the whole neighborhood on occasion, tubes are worth it.

Many recent vintage tube preamps have a slow start cycle built in. It slowly increases the voltage going to the tubes over a 20 to 45 second interval when you turn the preamp on.

Preamps that I know of with this feature include PrimaLuna, c-j and Aesthetix. If your preamp has this feature, I think you should turn it off if you won't be using it for an hour or so. The life of small signal tubes is being used up even when music is not being played through them, although at a slower rate than when music is being played through them.

I am not a tube or electronics expert, so if i am wrong about this, please correct me.

Tomcy6:
"Many recent vintage tube preamps have a slow start cycle built in. It slowly increases the voltage going to the tubes over a 20 to 45 second interval when you turn the preamp on."

I think you'll find that's because they used tube recifiers, not solid state ones they use today.

Cheers George

Thanks for the input guys, greatly appreciate it. I am getting mixed responses as to if I should turn it off when unattended, etc so I will just await more answers I guess.

My Lyr has a 20 second mute relay switch, does that mean it cannot explode or arch when I turn it on cold? Thanks guys.

Most tube gear sounds pretty decent within 10-15 minutes of being turned on so there is no good reason to leave the gear on all of the time--waste of energy and waste of the limited life of tubes. While there is a possible safety issue with leaving tube gear on unattended, the chances of a fire is extremely low, and such risk would apply to solid state gear as well.

Tubes are NOT like light bulbs, which come on instantaneously, so they are NOT as prone to thermal shock from being turned on. The tube may be subject to some damage from "cathode stripping" if the high voltage rail instantly powers up and the cathode is not yet heated enough to be emitting electrons. Better designs utilize a soft start circuit to prevent such problems, or if the amp uses a tube rectifier, the amp will naturally ramp up gradually. Overall, with most tube gear, there is more wear on the tubes from being left on when not in use than from the stress of being turned off and on more frequently.

What I never do is turn off an amp or preamp and then turn it back on without a fairly long interval in between (at least 10 minutes). I have seen tubes, particularly the rectifier, flash when this is done. While I have not noticed any permanent damage, this cannot be a good thing.