Help me solve static electricity problem

avoid a wool rug if you have one in your listening room.If the air is dry use a humidifier and possibly place plants in the room. The clothing that you wear might contribute. You can also do what Lon Channey Jr did in the movie man made monster!He wore a rubber suit.

It is because of the air being so dry in your home. I use a ultrasonic humidifier in the winter when it is really dry. Get one without the replaceable filter if possible. I also touch the side of the stand before I touch one of my components, just to make sure there is no static charge in my hand. A number of years ago I sent my preamp into protection mode and it would not come out. I had to send it in for repair. Since then I have been far more careful.

Someone in the past posted on constructing a ground...it was a brass door knob and resistor connected to ground. I think the resistor was just to prevent pain when you touched it. I ran some lamp wire to a ground on my APC power conditioner. I touch the bare end of the wire before touching any equipment. I can feel a tiny shock but nothing unbearable. Hope that is useful. Maybe you can find that older post. It's a bit more sophisticated than what I'm doing.

I agree with Al- a static shock should not cause your system to go into protection. My guess is something else is wrong.

Where I live low RH is just a fact of life in the winter, and even though I run 3 humidifiers shocks happen regularly. All of my electronic components have recieved several shocks and I have never heard any pops or had any problems with them.

Mark

Thanks for all the responses. I'll pass on the rubber suit and naked listening...even *my* wife isnt't that patient. LOL.

I'm using two separate 20-amp lines and Shunyata power conditioners on each line. The Classe runs through a Guardian and the rest of the gear runs through a Hydra Version II. I've got everything on a seperate filter. I just discovered that my digital interconnect was touching the single-ended interconnects that run from my preamp to the amplifier. This digital interconnect does not appear to be particularly well shielded. Hmmm. I moved it and will monitor...I've also repositioned several other interconnects. What do you think, Al?