Audio room floor question

Don't mean to steal thread however I have a similar situation. Concrete floor currently covered by carpet and pad. Considering covering concrete with plywood floor. Have considered 2 options for this. 1) Lay plywood directly on concrete; 2) Lay plywood over 1 1/2 inch closed cell insulation. Thoughts?

Leave the carpet and pad. Read Mapman's post above. I also have carpet over concrete and it is the best sounding room I could ever ask for.

As with Mapman,Mesch and Rrog my floor is carpet and pad over concrete. The acoustics in this room are exceptionally good IMHO.
Regards,

I use both bottom ported OHM Walsh speakers and rear ported Dynaudio monitors. The thin carpet and pad over concrete floor prevents a lot of bass interaction with the floor, especially with the bottom ports. When I use same speakers on the floor above with typical modern plywood flooring under similar carpet, bass can be overwhelming and harder to get under control.

I've also used front ported B&W P6 floorstanders and Magnepan planars in same rooms. Maggies were the least sensitive to flooring type sound wise for sure, but harder to get clean full extended bass out of. Much less interaction with the floor acoustics it seemed with those.

Thanks all! Based on your feed back I think I will leave well enough alone. I was hoping to avoid installing a wood floor but was willing to try it out if other's found it beneficial. Enjoy the interaction this forum provides, and this thread in particular.