I'll be fitting a Tecnoarm to my LP-12 this week.....very similar to your RB300 arm.
Is the Zu/Denon a good match with the Rega arm in terms of compliance, etc...?
Is the Zu/Denon a good match with the Rega arm in terms of compliance, etc...?
Rebuilding LP12; which tone arm
I am in the process of rebuilding a Linn LP12.I have replaced the sub chassis suspension springs, refinished the chassis and built a DC motor controller using a Maxon motor. It is all coming together really nicely and i am at a junction on where to go on tonearms.
Originally i had planned to built an air tangent tonearm. i have several of the pieces but somehow lack the motivation to follow through. I also have a Rega RB300 that i rewired and added VTA adjustment that i can install. I plan on using a Denon 103 cartridge (Zu rebuild). Should i install the RB300 or sell it and use the funds towards purchasing an Ittok.
I have become more seriously aware of the 80/20 principal where i believe one can achieve 80% of the desired end result with 20% of effort / funds. It is the last 20% of result that can cause one to spend the remaining 80% of funds.
In light of all of this what tonearm would you install?
In
Originally i had planned to built an air tangent tonearm. i have several of the pieces but somehow lack the motivation to follow through. I also have a Rega RB300 that i rewired and added VTA adjustment that i can install. I plan on using a Denon 103 cartridge (Zu rebuild). Should i install the RB300 or sell it and use the funds towards purchasing an Ittok.
I have become more seriously aware of the 80/20 principal where i believe one can achieve 80% of the desired end result with 20% of effort / funds. It is the last 20% of result that can cause one to spend the remaining 80% of funds.
In light of all of this what tonearm would you install?
In
9 responses Add your response
