Solid state to tube

@ghdprentice 

All my gear is tubed now. I would not consider going back

Good comments and I can relate with your amplifier transition/progression. I went from a Symphonic Line solid state amplifier to a couple of push-pull tube amplifiers. The el34 amp was utterly reliable. The KT 88/6550 was also, (with the occasional KT 88 failure). 6550 were even less prone to a failure.

Most reliable with zero problems has been my 300b SET of 13 > years. Probably due to the very simple circuit and high built quality. Only 3 tubes per mono block (Rectifier/driver/output). Literally maintenance free with beautiful sound. Tube amplifiers are durable and can be quite trouble free.

Charles

Very important what speakers are being used, and what is their efficiency ?

@charles1dad "Probably due to the very simple circuit and high built quality"

With less in the signal path, sometimes simple sounds better too 👍

Why?

I tried tubes and went back to SS.

The biggest, and I think consistent difference between good quality solid state and tube amplification is in slam. To me, after decades with high current solid state amplification, appreciated slam… which tends to be much greater in solid state. The midrange tends to be a tad leaner and the bass transients really fast… this gives the characteristic slap of fast bass. But, I have never heard this in live performance… amplified or acoustical. High quality tubed amplification tends to have a more fully fleshed out midrange and upper bass and the bass is finely nuanced… but the transient rise is slower… which is actually what I hear in live venues.

I get why one would like either… but the moment I heard the later (tubed)… the former was out the door for me. Did I loose something? Yes… but for me, what I gained was many times greater than what I lost.