Cable management....crossing at right angles or


Good morning,

I have been out of the hobby for a while, and now just getting things back into my system.

No matter how I try, I can't keep my cables isolated from each other, especially speaker and power. Is there anything besides the old saying of trying to cross at right angles, something..copper tape/Faraday sheets that you can put on the cables when they cross to reduce-eliminate interference or distortion/ EMI RFI?

Thanks,

Randy

 

randu

I wish I had a dollar for every time I have had to reconfigure my rack and have vowed that this time the result will be neat and organized, only to end up in the same place.

A rats nest of wires with no discernible pattern. 

@tony1954

+1

Unfortunately, same with me. I get the speaker cables out and on elevators… and generally I can separate the interconnect to my amp in front. But the audio racks have a rats nest.

I am sure it is in that category of tiny difference. But one you should avoid if you can. Tiny differences add up. But unless you have a huge room and lots of money (to buy extra lengths to allow crossing at right angles)… it will probably remain on one’s wish list.

Iv’e not heard of wraps or special tweats. But great question. One of the tweakers must have experimented. I look forward to hearing.

Your cables should be shielded, so positioning isn't as critical as say- two wires with just insulation being crossed.

Bob

A rats nest of wires with no discernible pattern. 

Rat's nests are very underrated/under appreciated. They serve a vital purpose.

All the best,
Nonoise