Hey Tony, shot home for lunch and I do still have them. They're yours.
To Raise or Not to Raise Heresy IV's
I've noticed the speaker cabinets moan a bit in the lower reaches of their range with or without a sub when they are on the floor and this has really started to annoy me. Ive been contemplating raising the H4's to get rid of this moaning, but the general consensus is that raising them will cause the bass to evaporate. I figured, if I'm using a sub anyway why should I care if the bass evaporates; I'll just bump up the sub.
I brought in 4 cinderblocks and removed the H4 stands. Initially it sounds fantastic and the moaning is gone.
What's my point in all of this? I was hesitant because of the opinions of others, but I tried it and I think there is very nice improvement, so.....if you use a sub and have vaguely considered raising your H4's, but have been worried about negative opinions, I think it is worth a shot.
TD
17 responses Add your response
@tonydennison When I had mine I experimented with them on the floor and then on a pair of JBL metal stands, pretty much the same as what @decooney shows in that first pic. I ended up preferring them on the stands, with a sub. I think i still have them. If you want them you are welcome to them, no cost. I'll have to check and confirm I have them.. |
+1 @decooney |
Another option rather than raising may be to put isolation pads like Auralex subdude under them, assuming right size available. That helps prevent interactions particularly on common suspended plywood floors that muddy the bass and obscure detail. I do that with my bottom ported Ohm Walsh speakers in rooms with suspended plywood floors. It's not just subwoofers that may benefit from floor isolation, rather, any speakers that deliver bass.
|
| Post removed |
| Post removed |
"Tony , they could be too close to the rear wall or corner." They are three feet off the wall. I spent a long time getting the proper distance. BTW the soundstage increased in depth too by raising the speakers.
"Make sure any tone controls are set to zero and mess around with placement " I have no tone controls.
"In my experience with H2 and H3 they work well on the floor, running full range with the subs crossover low , like 40 or 50 hz."
I had them on 50 before, I had to increase them to 60 to cover the loss.
"When you run a sub at a high crossover frequency , the sub starts to become directional... you can tell where it is in the room... "
This has not happened. Sounds great all around. Much better than it was and I thought it was great before.
Thanks for your comments.
T |
Tony , they could be too close to the rear wall or corner. Make sure any tone controls are set to zero and mess around with placement In my experience with H2 and H3 they work well on the floor, ru ning full range with the subs crossover low , like 40 or 50 hz. When you run a sub at a high crossover frequency , the sub starts to become directional... you can tell where it is in the room and thats something you want to avoid if possible.
|
