I'm once again changing speakers, so I'll need two sets to shotgun biwire. I'm tired of seeing the prices asked, and the recommendations made, for multi-thousand dollar products.
I don't know if I'm interested in going the Home Depot extension cord route either, though.
What about low-moderate priced wire that sounds good without the high price tag? Something full, big sounding, extended without being bright, with a good soundstage?
I won't hijack this thread any further, but appropos Audiofeil's list, take it from a long-term user, Atma-Sphere is right up there and the reason, it just occurred to me - duh - that he didn't mention them is because he sells the product. Kudos to him for that.
Making a ribbon speaker cable takes some work. You need to get some 12 gauge very thin copper ribbon. I am talking about thousands of an inch. Then you need to lightly sand with 320 paper and spray a thin coat of polyurethane. Do this to both sides. Leave the last half inch unvarnished. It is really hard to get this around a post. so I used a high quality rhodium on silver spade. The difference in sound over the magnet wire must be heard.
By the way, I probably will never replace my Speltz ICs.
I just came back. Now, with more listening there is a glitch in my system that I must remedy. If I had not heard it, though much more faintly, with the Speltz cables in, I would question my switch.
It is true, that though my system is even more transparent, and focused, the highs are too hot. This is a system that began as too dark. I know there are remedies.
I just recently replaced Theta bypass caps in my amps with V-Caps. That change brought a marked improvement, as others said it would. They also introduced that shake too much of Tobasco. Before I even think of going back to my Anti-Cables, I will try yet another bypass cap type.
If it wasn't already suggested, go to The Cable Co. New Hope, PA. (fatwyre.com). They have a lending library of cable. Great deals on used. Pick your price range and search their site. The price range on cables is mind-blowing.
Well, Reference systems don't mean all that much to me. You have to know your gear. I find that a lot of mastering people that are responsible for a part of the sound of these record we all listen to , may have a really odd room, speakers we don't all like, a "lower end" turntable, etc.
While they have good, hopefully transparent and detailed, full range gear, a lot of it wouldn't make the cut in a "high end reference system" from an audiophile.
There is a lot of very expensive stuff out there which doesn't sound that good as well.
You don't have to spend top dollar to get top quality sound. A Honda Accord is a better car than is a Mercedes 320 because its more comfortable, quieter, faster, corners better, etc. than the more expensive one. I know because I own both. The object of the game in audio is not to pay the most but to get to the sound. In that regard my or others' systems are very high end because when you close your eyes you are at the concert hall. I am a pro violinist and am at the concert hall most days of the week. I know that by adding additional colorations that may sound "kool" you leave the venue. Sony TV's look great because the color is pushed. One tires of anything not natural.
Audiofeil, I guess you are the authority on everything and we should all listen to you. In any case, please don't hijack my thread into a pissing match. This was supposed to be about alternatives to expensive speaker cables; not the best equipment available in high end audio. Let's come back to earth.
I am going by my experience, and the heaps of other people's testimony. I can prove to anyone, any "insulated" cord, regardless of cost, will spit.
People owning Scintillas are big on ultra thin silver or copper ribbons. I am going to try one within the week. I found a source that gives me yards of .003" ribbon already coated with urethane, which is what I was going to do anyway.
LOL What was that song refrain? oh yeah, "You don't piss into the wind...."
Most of the time people spend a hundred grand on audio is because they are in a sucker rut. My system cost less than twelve grand. Set up against one notch less than an Audio-Note system can be, mine wins hands down. Silver everything, oil capacitors, and a $140,000 price tag can't make up for the power and finesse of my system.
Start with the speaker. The Apogee Scintilla is argued to be the greatest speaker ever made. The amps I am powering it with play with it's 1 ohm like it was a toy. My preamp, by the same builder, is second to none. I am sure of that. At least it has trounced all comers.
My source, including an Audio Note DAC is a meager affair that has received a great fortifying operation by the same builder. It is in the power supply, and cap choices that make the difference.
There are relatively few outright geniuses in the audio world. Some just don't make good businessmen. That's why you haven't heard of them, or know their triumphs. In audio, just as with anything else, a large part of your system success is due to who you know. I am a lucky audio freak.
Back to cables. The Anti Cable SC is NOT the last word in cable making. It's just better than almost anything else out there, regardless of cost. And that ties neatly into what I was saying above.
To further clarify, there are good systems, reference systems, and SOTA [State of the Art] systems.
Although there are no hard and fast rules, I would say that a Ref. system will cost $50,000+, while a SOTA system is $100,000+! An audiophile reaching this level will spend copious amounts of time, trial, and trade-ins to reach audio nirvana. And they will use plenty of tweaks and ROOM TREATMENTS [if not even a specially built audio room]...you've all seen a few of these systems listed here.
Also, just dumping a bunch of money won't get you a Ref. or SOTA system. You can have a system that will be bettered by a system costing half as much!
To further complicate things, there are no absolutes in audio. In racing, the fastest car wins. In audio, we all have particular biases regarding what sonic signature we enjoy. It's like trying to judge the best flavor of pie!
Tweaks and cables will produce a much greater sonic change in a Ref. or SOTA system. And of course, there are audiophiles who spend more time fooling around and adjusting their systems than they do listening to music...there is nothing wrong with that. How many car enthusiasts do you know who spend more time in their garage than driving? Just enjoy, knowing that you are a member of a small, select group who is blessed [cursed?] and can appreciate the passion and magic of good sound!
Before this gets off track and evolves into a pissing contest about what's very high end and what's not let me add a few caveats to my prior posts.
To begin only a few components from a handful of manufacturers, IMO, can be considered "very" high end.
That being said my list of very high end products would include top offerings from the following, but not limited to these, manufacturers (in no particular order):
MBL Goldmund Zanden Wilson Focal JM Labs Aesthetix Dali Dcs Audio Note Kondo
We could add another couple dozen I suppose and everybody's list would be different. OTOH, we could all agree that certain products are not very high end. To list names is not fair and actually unimportant in that regard.
Very high end, I admit, is a subjective, relative, and nebulous term. I’d opine that less than 5% of the gear for sale on Audiogon meets my personal “very” high end criteria. If you agree, fine. If not, oh well.
In my system, the LAT international silver/copper hybrid clearly sounds better than the anti-cables - not even close. I won't spend truckloads of money on a cable, but there is a difference. However, LAT cables may not sound better in other people's systems so I won't presume that they will. Ditto for DH labs and AudioHorizons.
i've anticables as a 'sanity-test', and oddly they performed better than $3k cables under a diff config in my system.
but these days, they, like all budget cables i've tried, cannot hold a candle to the uber-$ cables i've had in (prana, jorma, transparent).
if your system isn't reference level, no point in buying expensive cables; but if it is, then you may very well find your biggest bang for buck improvement is indeed in cabling.
(i'll cover this phenomenon more in my review of prana cables in dagogo, due in a couple months)
Hi Audiofeil... No that's not true. I've never heard a system that didn't benefit from Paul's cables. If one's goal is to temper highs, color the mids, etc, then you can look elsewhere. That's not what audiophiles are after Audiofeil...
I've posted this before. I have a very high end system (you can see it listed under Opinions Please in Members systmes), and absolutely know that Anti-Cables are the best. I've had them all at one time or another, but am quite happy with Paul's cables. They look like wierd but sound wonderful.
Saxo, please note that Speltz and Anti Cable are the same thing. I agree with others: of the very cheap ones I have tried Speltz Anti Cables are by far the best. Also very suitable for biwire since they are so thin and can be twisted together
LAT international makes a very nice set of speaker and interconnect cables; Joseph Chow at Audio horizons makes nice speaker wire as well. I have the anti-cables and in my system, or maybe my ears, I thought they were OK but let through some digital nasties that these other cables didn't. DH labs also makes a pretty decent cable.
Lots of stuff. And not easy to audition alot of it. Probably need more opinions from others who might have contrary opinions on some of these suggestions.
One thing I don't want is something like Mapleshade, where the wire is fragile with barely any covering, as I don't want breakage or shorting problems. But I do understand too much dielectric and jacketing may degrade sonics.
I want to echo the comments about Speltz. I have tried many cheap and moderately expensive cables and prefer the Speltz over everything I have tried. You can afford to try it without penalty financially. I do not twist the wires. I tried it and went back to straight wires for both upper and lower modules of my VR-4JRs. I like his crimped on spades but also use them as bare wire. I do have to clean and treat the bare wire periodically. Good luck!
You might want to look at Cobalt Cable. I have used their stuff for quite a while and have been happy. Super quality construction and very reasonable prices. I am not affiliated, just a satisfied customer.
speaker wire to my dull set of ears do not make nearly as much difference as interconnects, even though they're often enormous and may even need two people to lift! okay, maybe not now, but that seems to be the direction the industry is heading towards. btw, what speakers are you changing to? there is one requirement though-- poorly made terminations are a disaster at either end of the cable, especially if the cable is stiff and/or heavy. i once had a spade lug barely hanging on from a well-used large set of cables, and the store had to re-attach it using as little solder as possible. and once you've used locking bananas you'll be spoiled for anything else. but i still have a set of esoteric multistranded OFC wire in the closet that i used on a pair of SF Guarneri's while i shopped for a "better" set. at a few bucks a foot they sounded fine to me. i later upgraded to transparent ref. w/MM. they look nice, but i didn't really notice a huge difference. that's not to say there wasn't an improvement, but it just was NOT a dramatic change.
I am very happy with Guerilla wire, silver for the woofer and copper for the mid/tweet in a biwire configuration, reasonable price (I think about 400-$900 for 3 meter pair), high quality construction and service.
Magnet wire is a single wire coated with only the thinest polyethylene. That's all that is needed. All the other crap speaker makers pile on their multi thousand dollar cables, like the aforementioned Cardas line, impart distortion to the signal.
Magnet wire comes in any gauge. I use 12 gauge. I am soon to try short runs of 12 gauge polyethylene sealed ribbons.
Hey, DF, can you explain how you do the 12 gauge thing? You use a bunch of dielectric covered 12 gauge runs, twisted or braided together, with a jacket over?
Magnet wire is what gauge? And how do you do it? What's the difference in sonics with these two methods?
I bought the Paul Speltz anticables and I'm very, very pleased, I didn't do a backflip when I installed them but I just don't think about speaker wire anymore, it just doesn't cross my mind. I went from $500+ PADs to the anticables.
Man, Dfhaleycko, you have said all there is to say, just about. For interconnects I would pay for Speltz's. It is far more sophisticated and stands the test against much more expensive ICs including silver foil.
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.
